428 750 UZS
The "heart" of the Arduino Uno – ATmega328 has on board 32KB of program memory and 2KB of RAM, as well as 1KB of power–independent data memory - this distinguishes Arduino UNO from boards of previous versions, like Duemilanove and Diecimila, which were based on a controller with half the amount...
187 500 UZS
In stock
Remote control. 4-Channel Remote Control 3V-7.4V 2.4GHz Transmitter + Receiver Module for RC Car/Boat Models Remote control distance: 50-100 meters Power supply voltage: A 6 V DC power supply is used on the receiving board, and a 3 V battery is used on the control panel (battery is not...
954 500 UZS
The SkyRC IMAX B6 Mini battery charger is a compact battery charger for charging any battery. Reliable, automatic, the entire charging process is controlled by a microprocessor. The user only needs to connect the charger to a mains voltage of 11-18 volts. Connectors for balancing Li-XX...
24 500 UZS
The transistor tester, the LCR-T4 ESR meter on the ATmega328 microcontroller allows you to determine the type and cap of electronic components (diode, NPN bipolar transistor, PNP, field-effect transistor, thyristor, etc.). And is a multi-functional tester that can measure a number of parameters...
81 750 UZS
The STM32L series includes microcontrollers whose architecture is primarily focused on achieving a minimum level of energy consumption while maintaining proper performance. To achieve the required characteristics, various methods are used, such as: flexible clocking system, control of energy...
170 375 UZS
The basis of the board is a dual—core Arm Cortex M0+ chip, with a core frequency of 133 MHz. The board has 264 KB of RAM and 2 MB of flash memory. In addition, there is a USB 1.1 connector and I/O channels, of which 26 are available to the user. It is possible to use interfaces 2 = UART, 2 =...
315 000 UZS
USB3300 USB HS Board is a communication board with an ULPI interface that will allow designers of specialized integrated circuits (ASICs), single-chip systems (SoCs) and programmable gate arrays (FPGA) to implement Hi-Speed Universal Serial Bus (USB) and USB On-the-Go (OTG) in their projects....
51 750 UZS
This BMS is used for 3.7V Li-ion (lithium-ion) batteries. Note: 1) This board is not suitable for high-power electronic tools, if used for screwdriver and drill, electric bicycle series, fishing machine and 1W LED, please do not buy it. 2) higher than 3A of the device, means that the...
54 500 UZS
ISD1820 module (Fig. 1) for recording and playback of one voice message up to 10 seconds long. The module includes an electret microphone for recording a message and buttons for recording, partial or full playback of a message. The recording is stored in the internal EEPROM memory of the...
54 500 UZS
The ISD1820 voice recording module is an electronic device for recording and reproducing voice messages for no more than 10 seconds. You will need this module in your projects related to speech commands. The frequency characteristics of the module are focused on recording and reproducing...
34 000 UZS
Metal backlit button (12-24V) without fixing is widely used in industrial equipment and amateur radio structures. Supply voltage 24 V Maximum current 2 A Kit button, nut The diameter of the landing hole is 16 mm The total length of the button is 34.8 mm Degree of moisture protection IP65...
664 250 UZS
DKP6012 Voltage regulator 10V-75V to 0-60V 12A Input voltage range: 10-75 V Adjustable output voltage range: 0-60 V Adjustable output current range: 0-12 A Output power: 0-720 W Output voltage setting resolution: 10 mV Output current setting resolution: 10 mA Power supply effect: CV less than...
156 750 UZS
The "Arduino UNO R3" beginner's Kit will be a great purchase for those who are starting their acquaintance with Arduino. A large number of various sensors and devices will make your acquaintance with this platform fascinating and unforgettable. This set provides ample opportunities to realize...
57 250 UZS
For those who are fond of programming, it is often a task to quickly and efficiently check whether the code is working or not. It is advisable to do this without programmers, redundant wires and low-level programming. Of course, there are Arduino-compatible boards, but they seem redundant...